Stower Energy FlameStower USB Charger

Product Information

The FlameStower is dead simple to use which means that having to use it after having a few frosty, adult beverages around the campfire is no problem. Learning and sharing information to aid in emergency preparedness as it relates to both natural and man-made disasters. My phone would usually lose more power than it gained from the Flamestower during the duration of charging. All of the sections are able to be adjusted for height and angle to accommodate working with many different sizes and shapes of backpacking stoves.

From its premium leather upper to to the Vibram outsole, Danner's Vicious Boot is built to handle the toughtest jobsite conditions. With no load (iPhone not connected to the Flamestower) the Flamestower would hold a fairly steady 5vDC, occasionally dipping to 4. This never influences our opinions or review content, and your support helps keep this site running.Picture one is what it did when plugged in, but that is all it ever did - gained no charge on that device. Even if it had achieved what it claimed, the amount of power needed by modern phones, gps units, and the likes exceeds 5W (way beyond this things 3W if it ever achieves that.

Setup takes less than a minute, and charging begins as soon as the reservoir is filled and the FlameStower is in place next to a fire source.

Modern living has so many benefits, but it has it’s weaknesses as well, such as in the case of smartphones, tablets and anything else that runs on a limited power source that requires charging from a USB outlet. If the water was simmering or boiling I would begin to see the voltage oscillate and become unsteady. So having noticed the unreliable charging of my iPhone, and the slow charging of other devices I decided to run a little test to see what was really going on. Lightweight and reliable, it works by conducting heat to a thermoelectric generator, which is in contact with a water reservoir — the combination of hot and cold produces enough juice to charge your device in as little as three hours.

This means that for phones, it should be able to create somewhere between two and four minutes of talk time for each minute on the charger. For the best results you need to place the centre of the Fireblade directly over and in the fire a half inch above the flame source, fill the water bath with water (it will evaporate so make sure you keep it topped up to get the best out of the charger) the thermal energy is transferred to the Thermoelectric Generator (TEG), the opposite surface of the TEG is in contact with the water reservoir, one side gets hot as the water keeps the other side cool and the temperature difference generates electricity. It works by the temperature difference between the water put into the reservoir and the blade that goes into the flame. Featuring IPX7 waterproof and sweatproof construction, the powerful wireless headphones deliver six hours of audio on a full c. Perhaps with a product revamp or complete redesign the Flamestower would be a more viable option, but as it is now I would not be able to recommend this product to anyone.The FlameStower consists of a folding metal stand, collapsible water reservoir, and protruding metal prong that slides into the flames of campfires, grills, or burners. It is lightweight, functions exactly as described and does the job - you can now charge your cell phone or any USB small device without solar. Not a lot of energy, but the low power demands of modern devices fundamentally change global energy strategies: one of the most powerful tools the world has known – a cellphone allowing instant communication and limitless knowledge – now fits in your pocket and needs only five volts to charge. Our articles, podcasts, and infographics inform our readers about developments in technology, engineering, and science.

The second one suffered the same distortion and damage to the housing, but remains operable up to this point. however its not very good for using to burn material for heat or recreation like a regular fire does, which is where this item would do better im thinking.Twenty-five-year-old Thomas Johnson fabricates his cool, modern industrial Fusion Wallet from 12 separate CNC-machined aluminum and hardwood components. Features like a non-conductive electrical shock-resistant sole, an oil-and-slip-resistant Vibram Vicious outsole, and a Danner Trailguard platform for protection and stability ensure you stay safe on the job.